I. Features

(1) Single/dual input for choice, built in optical switch for dual input, the switching  power can be set by the button in the front panel or by web SNMP.

(2)  Output adjustable by buttons in the front panel or web SNMP, the range  is down 4dBm

(3)  Maintenance function of one-time downward attenuation of 6dBm by buttons in the front panel or web SNMP, to facilitate the optical fiber hot-plug operation without turn off the device

(4) Multi- ports output, can built in 1310/1490/1550WDM.

(5) Standard RJ 45 port for remote control, we can provide output contract and web manager for choice, and also plug-in SNMP hardware can be reserved for update.

(6) With laser key to turn on/off the laser.

(7) With RF test function.

(8) Adopts  JDSU or Oclaro Pump laser

(9) Led displays the working condition of the machine

(10)Dual power hot plug power supply for choice, 90V～250V AC or -48V DC

II. Installation

Before installation

1. Please check if there is damage in outside of the machine

2. Please check the spare parts is complete or not, if not complete, please contact the seller.

Installation

1. Please keep at least 1.75inches (4.5cm) space for cooling if the machine installed  with other machines.

2. Please check the power supply socket and the grounding of the power supply, the grounding impedance should ≤4Ω, 220V power supply should be with three cables and the grounding cable should be in the middle, Unfitted grounding will damage the device or influence the signal quality.

3. Please make sure the power supply switch to off in the rear panel

4. Please confirm the fiber port is clean before connection the fiber.

III. Set and Operation

Main Parameters